LOGOSOL LAKS 500 15KW 460v 60HZ
The heart in the frame saw is the frame with up to twenty sawblades that are pulled up and down with a balanced flywheel as a counterweight. The frame, the flywheel and the mechanical feeding work in perfect harmony, and this can be observed when it is sawing. The sound level is low and reminds of a puffing steam locomotive. Timber cants are the raw material you start with. Many small-scale sawyers who today use a circular sawmill, a band sawmill or a Logosol Sawmill can reach industrial capacity with the help of the Logosol-Laks frame saw. The logs should be sawn on two sides before they are fed into the Logosol-Laks frame saw so that the lumber is edged before it is cut into boards. This gives a controlled process and minimal handling of the lumber. Without ado the cants are turned into sawn products.
Pleasant on the site as this sawmill work is neat and tidy. What little sawdust that comes from the thin blades, is transported away by a relatively small sawdust extractor. An additional nozzle vacuums the top side of the cant so that the boards become completely clean after they have been sawn.
The Logosol-Laks frame saw relentlessly works away, without interruption or trouble, hour after hour. To keep it working, the sawn boards have to be carried away, and a new cant has to be sawn within only a few minutes. In practice, the Logosol-Laks frame saw is, despite the low feed rate, in almost every case the quickest on the working site.
After 8-10 hours of operation, or after about 100 logs, the tungsten-carbide toothed sawblades have to be removed from the frame and then sharpened with the sharpening machine that always comes with the Logosol Laks frame saw. The blades are mounted in fixed positions in a comb-shaped holder. This is an excellent system, which makes replacing blades a quick operation and ensures that the blades always come in exactly correct position. The entire procedure takes less than 20 minutes.
All Logosol-Laks are powered by an 11 kW (15 hp) electric three-phase motor. The model 330 can also manage on 7.5 kW (10 hp). If you do not have access to electricity, all the models can be run by a 17 kW (23 hp), environmentally friendly combustion engine. Here we have maybe the world's highest capacity per used energy mass; around 500 meters/litre (6300 linear feet/gallon) of fuel or, with electricity, 100 meters/kWh (328 linear feet/kWh). That this is environmentally friendly is obvious. In addition, it does not require any extraordinary installations or fuses. For some people this is just a matter of saving money, but in many places around the world it is a prerequisite.
Example of capacity: If the frame saw is equipped with 12 sawblades and you are going to produce 25 mm (1") thick boards from a 300 mm (12") wide cant, it is possible to place two cants, of which one is 100 mm (4") and the other 50 mm (2") high, on top of each other. This way you get the capacity to cut almost 1000 meter/hour (3300 linear feet) per hour.