• .063IN_IC.PNG
Cannon 68

Cannon 68" Double Ended Milling Bar for Lucas Slabbing Attachment CDE-LM2-68-63

Cannon 120

Cannon 120" Double Ended Milling Bar CDE-G1-120-63

Cannon 96" Double Ended Milling Bar CDE-G1-96-63

CDE G1 96 63
Double ended chainsaw bar for milling slabs. These bars specifically made for chainsw milling and designed to be used in conjunction either with two chainsaw powerheads, or one chainsaw and a helper handle (stiinger) on the other end. Cannon bars are simply the best chainsaw bar made. If you are serious about the equipment you run, this is the bar for you. All bars are hand made from the finest steel, which is cold rolled, heat treated, annealed, stress relieved and surface ground to provide the best possible characteristics of wear resistance, strength, durability, straightness and elasticity. Rails are hand ground, not milled, to an accuracy of .002 of an inch for straighter cuts. Rails are also flame hardened to 5 points more than the saw chain itself.

Important Note: This is a special order bar. May take up to 8 weeks to make if not in stock. Extra shipping charges may apply.

Shipping Weight 32.0 lbs.

Oversized or Overweight Item.
Please call 1-800-322-4539 for a shipping quote.

More Information
Length 96" (244cm)
Pitch Hardnose
Gauge .063" (1.6mm)
Maximum Cutting Width 84" (215cm)
Drive Link Count *280 (.375") or 253 (.404)
Recommended Chainsaw Size 6.0 cu.in (90cc) and Larger
Note Drive Link Counts can vary slightly based on the chainsaw used and are only approximate.
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account