Bailey's

Adding to cart...

Only $89.99

Item # ORF 535044

Ships in 3 to 5 Days

10" Oregon Sculptor Carving Bar - Dime Tip (535044)

Long awaited carving bars from Oregon have finally arrived. The Sculptor is manufactured from high-quality steel with precision gas-welded high cobalt/chrome alloy hardfacing material for superior nose performance and life. So you can dig into your project knowing that your bar has what it takes. To help keep that bar looking top notch there is a clear-coated, brushed steel for distinctive and durable appearance and finish. These professional carving bars are available with either dime tip (shown here) or quarter tip.

All Oregon Sculptor bars come with Multi-mount which fits most popular chain saws used for carving: Dolmar, Echo, Husqvarna, Oleo-Mac, Poulan Pro, Shindaiwa, Tanaka, Stihl, Zenoah and others.

Only $89.99

Item # ORF 535044

Ships in 3 to 5 Days

email product to a friend

Specifications

Product Q & A

Reviews

See the brochure for the Sculptor (669K pdf file)

Length: 10" (25cm)
Nose Size: Dime Tip (10mm)
Chain Type: 1/4" pitch chain - 25AP or 10SC
Drive Link Count: 60dl on most saws

Showing questions 1 - 2 of 2

Page: 1

Q.	Wondering if this bar would fit with the Husqvarna 334T or 339?
A.	It will mount on those saws fine, but like with all dime tip carving bars it is highly recommended you use a 1/4" sprocket and chain.
	187 people found this answer helpful.
	Was this question helpful? Yes
	Posted by: Adam B from DE on 9/25/2009

Q.	I have an 3300 Homelite would this bar fit this saw?
A.	Greetings - It would mount on the saw but as with many other saws there is no 1/4" sprocket, which you need to run the 1/4" chain. Any other chain cannot make the tight corner around the tip, so not only do you loose the fine detail, but the bar will wear out much faster than with 1/4" chain. If you ... (See full answer) Greetings - It would mount on the saw but as with many other saws there is no 1/4" sprocket, which you need to run the 1/4" chain. Any other chain cannot make the tight corner around the tip, so not only do you loose the fine detail, but the bar will wear out much faster than with 1/4" chain. If you can find a Rim & Drum system for your saw then you can get the CSR 14, 1/4" pitch rim, and then you could use the 1/4" chain. But you can always use your Homelite to block out the figure. Many of smaller Husky, Echo & Stihls have the 1/4" sprocket and can often be picked up at a good price used. The smaller the saw the better because almost no power is needed to run these carving bars and chains. (Hide full answer)
	190 people found this answer helpful.
	Was this question helpful? Yes
	Posted by: Tim from ct on 12/1/2009