| Q. |
I can't find the dimensions on the slabbing brackets. How long? Can you put them together?
|
| A. |
The brackets are 16" long and you can't put them together.
|
| |
395 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: Ron W from Missouri on 1/26/2008 |
|
| |
| Q. |
From the illustration, it looks like you would have to drill a new hole through the width of the 2x4 for every different length of log. That or else cut every log to the exact same length. Is this correct?
|
| A. |
Yes, you can reposition one end of the bracket by drilling several holes on one side of the 2x4's.
|
| |
332 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: David C from WA on 8/15/2008 |
|
| |
| Q. |
I have never used an Alaskan Mill. I am looking at using large white pine on my hunting property for lumber. I watched the video on the first cut. Do you have info on cutting the rest of the log? How do you attach the mill without marring the log surface?
|
| A. |
Marring the log surface is not an issue for lumber. Ripping chain will leave a smoother cut than standard cross cut chain, plenty smooth for lumber. Making a flat first cut is the key, then all the other cuts should be accurate. There is little published info out there on the mill, so if you have a
...
(See full answer)
Marring the log surface is not an issue for lumber. Ripping chain will leave a smoother cut than standard cross cut chain, plenty smooth for lumber. Making a flat first cut is the key, then all the other cuts should be accurate. There is little published info out there on the mill, so if you have any questions once you start don't hesitate to call us for assistance. (Hide full answer) |
| |
226 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: Goose from WI on 10/30/2009 |
|
| |
| Q. |
Are they 16ft or 16 inch long?
|
| A. |
16 inches long.
|
| |
76 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: SHAWN G from VT on 1/30/2012 |
|
| |
| Q. |
Is there a minimum diameter that a log needs to be when using these slabbing brackets? I would be using the Small Log Mill, G777. Thanks.
|
| A. |
The minimun diameter of the log should be 12" when using the slabbing brackets.
|
| |
8 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: ANTHONY C from NY on 3/6/2013 |
|
| |
