| Q. |
I have a Stihl with a 24 inch bar. Would this also go with the carry-case that I already have with my 460 20
|
| A. |
Both the Stihl and the Husky cases have OEM scabbards that fit specifically to the brand of case (Husky item # 531 30 05 39 for the POWERBOX); i.e., their design keeps them from sliding out of the case. This scabbard would fit the bar; however, it wouldn't match the slot on the case.
|
| |
499 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: jon from AZ on 12/29/2007 |
|
| |
| Q. |
Where can I get one that is 36" long? Do they even make one that long?
|
| A. |
Not that we've seen. If you come across one please let us know the source.
|
| |
372 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: Mitchell from VA on 2/24/2009 |
|
| |
| Q. |
How well does this design stay attached to the bar? Do the slots tend to spread in time so that it easily falls off? Thanks
|
| A. |
The slots is wide enough to fit over the chain, and the plastic is thick and hard enough it shouldn't spread. The tip has a spring that pushes outward and closes the open ends of the cover. Inside the slots (sorry, impossible to show in a photo) there are spaced ridges that will keep the unit from s
...
(See full answer)
The slots is wide enough to fit over the chain, and the plastic is thick and hard enough it shouldn't spread. The tip has a spring that pushes outward and closes the open ends of the cover. Inside the slots (sorry, impossible to show in a photo) there are spaced ridges that will keep the unit from sliding off. If the spring weakens with time & use a rubber band would keep it attached securely. (Hide full answer) |
| |
357 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: Jim W from Houuston on 4/23/2009 |
|
| |
| Q. |
Hi, What is the overall length of this cover. Can the ends be trimmed. Thank you.
|
| A. |
The overall length of this bar guard is 25-1/2" long.
|
| |
254 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: SUNG K from MA on 9/22/2010 |
|
| |
| Q. |
Do you have 18 inch bar guards or does the 24" have to be trimmed down?
|
| A. |
Yes, we don't have exactly an 18" bar guard. There is a 202" but that will have to be trimmed too. (See - 196 20). The only way around trimming is to by a 16" and that will cover most of the bar.
|
| |
48 people found this answer helpful.
|
| |
Was this question helpful?
Yes
|
| |
Posted by: GERRY W from GA on 1/2/2013 |
|
| |
